UDS1-BD (UDS1 Interface Circuit Pack)
Issue 4 May 2002
10-1877 555-233-123
PASS Remote DS1 endpoint is in-service. Neither a Blue alarm nor a
Line Loopback alarm nor a Payload Loopback Alarm is
detected by the UDS1 Interface circuit pack.
0NO
BOARD
The test could not relate the internal ID to the port (no board).
This could be due to incorrect translations, no board is inserted,
an incorrect board is inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Execute the
add ds1 UUCSS command to administer the UDS1
interface if it is not already administered.
2. If the board was already administered correctly, check the
error log to determine whether the board is hyperactive. If
this is the case, the board is shut down. Reseating the
board will re-initialize the board.
3. If the board was found to be correctly inserted in step 1,
then issue the busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID
and the port.
Table 10-674. TEST #139 Blue Alarm Inquiry Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
