Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-26 Issue 4 May 2002
Output (Page Three)
The following example shows the output from page 3 of the change
system-parameters maintenance command.
Field descriptions (Page Three)
Modem Connection
On page 3 of the example forms, 11 fields disappear when the Modem
Connection? field is set to internal. In this example the Modem Connection
field is set to external, revealing the 11 fields.
The first 2 fields on page 3 establish the data format for transmitting serial data
from the switch to the modem. The two valid combinations for these 2 fields are:
■ Data Bits = 8, Parity = None
■ Data Bits = 7, Parity = (odd, even, mark, or space)
Modem Connection
Valid entries are internal (default) or external.
Modem Name
This field is 20 characters long and will permit alpha-numeric characters to
provide a unique qualifier for a given modem. ( )
RTS/CTS Enabled
This field will inform the modem that communication with the data source
UART will be driven with RTS/CTS flow control. This field is 6 characters
long and is case in-sensitive. (\Q3)
change system-parameters maintenance Page 3 of 3
MAINTENANCE-RELATED SYSTEM PARAMETERS
Modem Connection: external
Data Bits: 8
Parity: none
Modem Name: _______
RTS/CTS Enabled: \Q3 Auto Answer Ring Count (rings): S0=10
Asynchronous Data Mode: &M0&Q0 Dial Type: T
DTE Auto-Data Speed: ______ Adjustable Make/Break Ratio:
Disable Data Compression: ______ Dial Command: D
Enable Error Control: ______ No Answer Time-out: S7=255
Misc. Init. Param: ______________
Help/Error Message Line
To Next Page
Loading...
