test hardware-group
Issue 4 May 2002
A-125 555-233-123
If the system technician presses HELP after entering “test hardware-group carrier”
the following message appears:
Enter carrier location:
[’cabinet’(1-3)]; carrier (A-E)
If the system technician presses HELP after entering “test hardware-group system”
the following message appears:
Entry is not required
If the system technician presses HELP after entering “test hardware-group spe” the
following message appears:
Entry is not required
Error Messages
If there is another “test hardware-group” active the following message appears:
Command aborted - another hardware-group
test already in progress
If an “add station” command is entered for a non-customer translated port at the
same time as it is being tested because of the “test hardware-group” command
with the ’all-ports’ option the request to “add station” will fail and the following
message appears:
Object in use; please try later
If an invalid physical location is specified with the “test hardware-group board”
command the following message appears:
Board invalid
If an unassigned board is specified with the “test hardware-group board”
command the following message appears:
Board not assigned
If an invalid carrier is specified with the “test hardware-group carrier” command
the following message appears:
Invalid carrier specified
If an invalid cabinet is specified with the “test hardware-group cabinet” command
the following message appears:
Invalid cabinet specified
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
To Next Page
Loading...
