Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-152 Issue 4 May 2002
Output
The following shows an example output for the C-LAN traceroute command. For
Medpro or Prowler boards, the clan-port (1-17) qualifier does not appear.
Field descriptions
clan-port
This CLAN entry identifies the port on the CLAN board from which the
traceroute command is issued. This field appears only if the board is a
CLAN board.
Hop
The node number (in sequence). The first node (0) is the address from
which the traceroute command is issued.
Time (ms)
Time from the board to each intermediate destination in milliseconds. If an
error occurs at a node, the entry is repeated with an error code immediately
following the time. Error codes and their meanings are:
■ ! Unable to reach port
■ !N Unable to reach network
■ !H Unable to reach host
■ !P Failure between endpoints
■ !F Need fragmentation of data packet
■ !S Source return failure
■ !X Packet blocked by filter
IP Address
The 32-bit network address.
traceroute ip-address 135.9.1.22 board 1C14 clan-port (1-17)
TRACE ROUTE RESULTS
Hop Time(ms) IP Address
0 from address 135.9.1.22
1 03,10,05 134.9.14.23
2 11,20,03 134.9.5.103
3 22,01,25 106.245.27.205
4 22,01,25 !N 106.245.27.205
To Next Page
Loading...
