Error Messages from Chapter 8: Maintenance
Commands
555-233-123
A-154 Issue 4 May 2002
If the standby SPE is not in the standby mode and is busy running tests, the
following message appears:
Standby SPE busy with another task;
for information use ’status system’
If the standby SPE has not completed initialization, the following message
appears:
Standby SPE memory not refreshed; Use ’refresh spe-standby’
If the active SPE cannot communicate with the standby SPE after the standby
SPE is properly upgraded, the following message appears:
Upgrade failed; no communication with
standby after new software booted
If the SPE-interchange failed and the new software cannot be run in the active
SPE, the following message appears:
Software upgrade failed, could not perform an interchange
To Next Page
Loading...
