Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-138 Issue 4 May 2002
9ynny
anyny
byyny
cnnyy
dynyy
enyyy
fyyyy
Set
Vector
Command
Option
The user-specified SPE prior to the core dump. For simplex SPE
systems this field is always
spe-active unless the vector is cleared or
not set. In duplex SPE systems, the field is either
spe-active or
spe-standby unless the vector is cleared or not set. If the vector is
cleared or not set in either a duplex or simplex SPE system, this field is
blank.
Core
Dump
Time
The time of the core dump for SPE A and SPE B. If the system has a
simplex SPE, a timestamp for SPE A (or the active SPE) and non
duplicated SPE” are displayed for SPE B. If the core dump cannot be
accessed,
can’t access displays for the corresponding SPE. For
example, in a High or Critical Reliability System where SPE B is not
refreshed, SPE B displays
can’t access instead of a timestamp. If
the MSS device storing the core dump timestamp is busy for any reason,
device busy displays at the terminal.
Table 8-3. Vector-Condition Mapping — Continued
value warm-start cold-2 cold-1 reboot
Continued on next page
To Next Page
Loading...
