Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-206 Issue 4 May 2002
Processor Channel Control
0xD0 - outgoing control message
Message events for R1:
0x00 - Request Reset of Logical Channel
0x05 - Ack. Reset of Logical Channel
0x06 - Flow Control Uplink
0x07 - Release Uplink Flow Control
0x0A - Flow Control Downlink
0x0B - Release Downlink Flow Control
Message events for R3:
0x00 - Request Reset of Logical Channel
0x08 - Connect Processor Channel
0x09 - Disconnect Processor Channel
0xD1 - X.25 incoming control message
R1 Message events:
0x01 - Performed Requested Reset of Logical Channel
0x06 - Resetting Logical Channel
0x0A - Level 3 Restart
1
R3 Message events:
0x01 - Performed Requested Reset of Logical Channel
0x06 - Resetting Logical Channel
0x08 - processor channel connected
0x09 - processor channel disconnected
Message[1] = processor channel number
Message[2] = message event
Message[1] = processor channel number
Message[2] = message event
1. If this event occurs, one restart for each logical channel will be written into the MST trace.
To Next Page
Loading...
