Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-208 Issue 4 May 2002
Timers:
0x00 - ST2(session connect)
0x01 - ST3(retransmission)
0x02 - ST4(resynchronization)
No count
0x03 - ABT1(abort session 1)
0x04 - ABT2(abort session 2)
0x05 - State Timer
0x06 - Message Timer
Protocol Machine States:
Message[3] = countdown from A1
Message[3] = protocol machine state where timeout occurred
Message[3] = protocol machine state where timeout occurred
Message[3] = protocol machine state where timeout occurred
Message[3] not used
BAD_STATE 0x00 /* 0 is very common, don’t use as a state */
PT_UNALLOC 0x01 /* port is un-allocated */
QUIESCENT 0x02 /* quiescent - allocated but not used */
ENTER_wSA 0x03 /* entering wSA - reset issued, not ABT/CON */
W_ACCEPT 0x04 /* Waiting for Session Accept*/
DATA_XFER 0x05 /* Data Transfer State*/
DATA_RESYNC 0x06 /* Resynchronization state */
PRI_ALLOC 0x07 /* pri port allocated but not yet used */
PRI_CONN 0x08 /* pri port connected */
HIGH_STATE 0x08 /* Highest value a port state can be*/
To Next Page
Loading...
