save announcements
Issue 4 May 2002
8-281555-233-123
Simplex
In a simplex system, no options for the save announcements command exist.
This command saves announcement files to the MSS device.
Duplex
If no options are specified, the system saves announcements to both processors’
MSS devices.
Feature Interactions
!
WARNING:
Manager I is blocked for other activities until the command completes (up to
45 minutes).
■ If no announcement and no NETCON data module are administered, the
system denies the command.
■ If the announcement data module port is out of service or active
(performing an announcement playback), the system denies the command.
■ If no announcements are on the board or a user is in an integrated
announcements session, the system denies the command.
■ If the board is currently uploading or downloading, the system denies the
command. Users cannot record integrated announcements after the save
announcements command commences even though 15 channels are
available for announcement playback (one is reserved for uploading and
downloading).
■ If no tape is in the tape drive or the tape is write-protected, the command
aborts during a save. The command also aborts if no NETCON data
module is available.
■ The save announcements command is not allowed if the MSS is in use.
The MSS may be in use by either another user or by maintenance.
Action/
Object Qualifier Qualifier Description Logins Default
Feature
Interactions
save
announcements
spe-active
spe-standby
forces the system to write
announcement data to specified
devices in active processors.
forces the system to write
announcement data to specified
devices in standby processors.
Examples:
save announcements
save announcements spe-active
save announcements
spe-standby
init
inads
craft
cust
rcust
none see below
To Next Page
Loading...
