Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-306 Issue 4 May 2002
Field descriptions
Start Date
Date and time that interval begins.
“cumulative” = date and time of the last reboot or execution of
clear audits cumulative.
“peak-hour” = date and time of the beginning of the peak hour
since the last reboot or execution of a clear audits cumulative
or clear audits peak-hour.
# of Audit
Cycles
Completed
Number of audit cycles completed in the specified interval. (0 –
999999) Asterisks indicate numbers that exceed 999999. The
switch executes audits in a set order. After all audits execute,
the switch restarts the sequence.
Since this field shows the number of completed audit cycles, it is
possible that individual audit values, can be larger than the
values described below (if the switch is partially through another
audit cycle). Audit Cycles numbers do not apply to these audits
that execute as part of scheduled maintenance.
Audit Name
Audit’s name that detected an error or aborted. A few audits do
not run in the normal audit sequence. Instead, they execute as
part of scheduled maintenance and are marked with “(SCH)”
following the audit name.
# Cycles Fixed
Data
Number of times that the audit ran, in the specified interval, and
found a fixable problem. (0–65534) Asterisks are used form
numbers that exceed 65534.
# Cycles Could
Not Fix Data
Number of times that the audit ran, in the specified interval, and
found an unfixable problem. The audited switch data is
inconsistent when this happens. (0–65534) Asterisks are used
for numbers that exceed 65534.
# Cycles Audit
Aborted
Number of times that the audit ran, in the specified interval, and
aborted due to an internal error. (0–65534) Asterisks are for
numbers that exceed 65534.
First Error
Date and time that the audit first detected fixed data, could not
fix data or audit aborted problems since the last “clear audits
cumulative” command. Format: MM:DD:hh:mm (for example,
03/27/14:31 for 2:31 pm, March 27th). This field appears with
the “status audits cumulative” display.
Most Recent
Error
Date and time that the audit last detected fixed data, could not
fix data or audit aborted problems since the last “clear audits
cumulative” command. Format: MM:DD:hh:mm (for example,
03/27/14:31 for 2:31 pm, March 27th). This field appears with
the “status audits cumulative” display.
To Next Page
Loading...
