Avaya Definity SI - Page 567

status bri-port
Issue 4 May 2002
8-317555-233-123
ASAI 0-126 Hyperactive ignore ignore Link has sent too many messages
per unit time.
BRI Signaling suspends. System
timeouts in 60 seconds and
attempts reactivate the link. If links
remain in this state while no activity
occurs at BRI endpoints:
1. Ensure that SPID switch
administration and endpoints
are consistent. Verify repairs by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the signaling
link is L3-Established.
2. Replace the endpoint. Verify
repairs by executing the status
bri-port PCSSpp command.
Determine that the L2 state of
the signaling link is
L3-Established.
ASAI 0-126 L3-
Restarting
ext The switch sends a Restart
message to the adjunct but has not
received a Restart Acknowledgment
message from the adjunct.
ASAI 0-126 L3-
Restarted
ext After receiving a Restart
Acknowledgment message, the
switch sends a Heartbeat message
to the adjunct and awaits a
response.
ASAI 0-126 L3-
Established
ext Normal state for ASAI adjunct.
Table 8-10. Status BRI-Port Command Interpretation — Continued
Endpoint
Types
TEI
Range Layer 2 State
Voi c e
Extension
Service
SPID Description /Recommendation
Continued on next page