status conference
Issue 4 May 2002
8-327555-233-123
Meet-me
number
The Meet-Me Number administered for the Meet-Me Extension.
()
Dial Type
“in” = dial-in to join endpoint to conference.
“out” = dial-out to join endpoint to conference.
In Use
“y” = the endpoint is in use and is fully-connected on all media
in an active conference.
“c” = the endpoint is in use and is fully-connected; however, the
endpoint has changed conference audio or video capability or
conference rate due to rate adaptation. This condition requires
analysis of this endpoint’s capabilities and mode fields to
identify reduced capability.
“e” = the endpoint is in use but has capability problems. The
endpoint lacks one of the required capabilities (Vid, Bhl, MLP) to
fully participate. For MLP capabilities, see the “T120” field. This
condition requires analysis of this endpoint’s capabilities and
mode field to identify the missing capability.
“f” = the endpoint is in use but not connected to all media. The
endpoint declared all required capabilities (channel/video/
audio/data) but is not fully connected to all conference media.
This endpoint may be connecting, failed to connect, or is not a
valid video source. This condition requires analysis of this
endpoint’s capabilities and mode fields to identify the problem.
“n” = the endpoint disconnected during a conference or
unsuccessfully attempted to connect to a conference.
“blank” = the field is blank until the first call from or to the
endpoint.
Chl
“y” = the endpoint has the required number of channels.
“e” = the endpoint does not declare support for the correct
number of channels and cannot participate fully in the
conference.
“n” = the endpoint declares the correct number of channels, but
not all join the conference, due to a network or endpoint
problem.
“blank” = Audio add-on endpoints set the Chl field to blank.
To Next Page
Loading...
