Maintenance Commands and Trouble-Clearing Aids
555-233-123
8-374 Issue 4 May 2002
Field descriptions (page 1)
Error Counters form (page 2)
Link Number
Administered link number (assigned by add/change
data-module command)
Link Status
Displays no, yes, unavail, connected, disconnected,
enabled, out-of-service, or restarting
Link Type
The type of interface according to the physical/link
protocol(s) immediately “below” the network layer in
the protocol stack (ethernet, ppp, bx.25)
Link Name
Administered link name (assigned by add/change
data-module command)
Service Port Location
Administered port location (assigned by
add/change data-module command)
Service Port Data
Extension
Administered extension number (assigned by
add/change data-module command)
Service State
Displays: in-service/idle, in-service/active,
disconnected, out-of-service, maintenance busy,
in-service, inactive, active, idle
Node Name
Administered node name for TCP/IP endpoint
(assigned by add/change data-module command)
Source IP Address
IP address administered for node name (assigned
with change node-name or add/change
data-module commands)
Enabled
y (yes) or n (no)
Maintenance Busy?
y (yes) or n (no)
Active Channels
Number of active channels
status link 1 Page 2 of 3
ERROR COUNTERS
Reset Time: 04/08 14:46
Last Hour Start Time: End Time:
Incoming Received: Unicast Pkts Multicast Pkts Octets
Since Reset
Last Hour
Incoming Dropped: Error Pkts Discard Pkts
Since Reset
Last Hour
Outgoing Transmitted: Unicast Pkts Multicast Pkts Octets
Since Reset
Last Hour
Outgoing Dropped: Error Pkts Discard Pkts
Since Reset
Last Hour
CRC Check: 0 Collision Count: 0
To Next Page
Loading...
