test inads-link
Issue 4 May 2002
8-447555-233-123
Once the call is answered by INADS, the system sends a message with a test
alarm type. INADS acknowledges receipt of the message and creates a trouble
ticket. The trouble ticket is closed immediately and has a “INADS LINK TEST”
message entered in the description field. If an alarm is raised while the test call is
up, the system does not send an alarm message over the existing link. The
normal retry mechanism is followed, which means an attempt to make a call to
INADS to report the error takes place 7 minutes later. An INADS trouble ticket is
created only if the connection is successfully established and a message is sent
to the system acknowledging that INADS received the system message.
The Maintain Process Circuit Packs field must be set to yes on the inads
and technician permission forms. This provides permissions to execute the test
inads-link command. This field can be changed by executing a change
permission login command.
No alarms are raised on the system and attendant alarm and acknowledgment
lamp states are not changed as a result of the test inads-link command. The test
does not run during periodic or scheduled maintenance.
Output
Action/Object Qualifier Qualifier Description Logins Defaults
Feature
Interactions
test inads-link 1
2
First OSS telephone number
Second OSS telephone number
Examples:
test inads-link
test inads-link 1
test inads-link 2
init
inads
craft
nms
1st OSS
number
none
Command
successfully
completed
Test passed
Command failed Link was up, there was an active alarm that the switch needs
to report, or there was a problem with the call.
NOTE:
An entry is made in the error log describing why
the inads-link test failed.
To Next Page
Loading...
