Maintenance Object Repair Procedures
555-233-123
10-20 Issue 4 May 2002
1000 ABORT System resources required to run this test are not available.
The port may be in use.
1. Use the display port PCSSpp command to determine the
voice port extension of the port.
2. Use the status station command to determine the service
state of the port. If the service state indicates that the port is
in use, you must wait until the port is idle before retesting.
3. When the port it idle, retry the command at 1-minute
intervals a maximum of 5 times.
1001 ABORT System resources required to run this test are not available. Try
(a).
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions, or it may have
time slots out-of-service due to TDM-BUS errors. Refer to
“TDM-BUS” to diagnose any active TDM-BUS errors.
1. If system has no TDM-BUS errors, and if it is not handling
heavy traffic, retry the command at 1-minute intervals a
maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The
system may be oversized for the number of Tone Detectors
present, or some Tone Detectors may be out-of-service.
1. Resolve any “TTR-LEV” errors.
2. Resolve any “TONE-PT” errors.
3. Retry the command at 1-minute intervals a maximum of 5
times.
1004 ABORT The port was put in use during the test. The test has been
aborted. Use the display port PCSSpp command to determine
the voice port extension of the port. Use the status station
command to determine the service state of the port. If the port is
in use, wait until the port is idle before testing.
1020 ABORT Test disabled by background testing. Use the status station
command to determine when the voice port is available for
testing.
2000 ABORT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals a maximum of 5
times.
Table 10-8. TEST #9 NPE Crosstalk Test — Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
