Maintenance Object Repair Procedures
555-233-123
10-76 Issue 4 May 2002
2000 ABORT Response to the test request was not received within the
allowable time period.
2100 ABORT Could not allocate the necessary system resources to run
this test.
1. Retry the command at 1-minute intervals a maximum of
5 times.
1 FAIL This does not indicate a hardware problem. The switchhook
audit failed. The other updates were not performed because
of this failure. This may occur when the audit is performed at
the same time that the terminal equipment goes off-hook.
Use the status station command to determine when the port
is available for testing.
1. When the port becomes available for testing, retry the
command at 1-minute intervals a maximum of 5 times.
Table 10-28. TEST #36 Station Status and Translation Audits and Updates Test
— Continued
Error
Code
Tes t
Result Description/Recommendation
Continued on next page
To Next Page
Loading...
