AN-LN-PT (Analog Line Port)
Issue 4 May 2002
10-115 555-233-123
NPE Crosstalk Test (#6)
This test verifies that the port’s NPE channel talks on the selected time slot and
never crosses over to time slots reserved for other connections. If the NPE is not
working correctly, one-way and noisy connections may be observed. This test is
usually part of the long test sequence and takes about 20 to 30 seconds to
complete.
Table 10-38. TEST #6 NPE Crosstalk Test
Error
Code
Tes t
Result Description/Recommendation
ABORT Necessary system resources could not be allocated to run this
test.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
1000 ABORT System resources are unavailable. The port may be busy with
a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station’s
extension.
2. Enter status station extension to determine the service
state of the port.
3. If the port is in use, wait until the port is idle. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1001 ABORT System resources required to run test are not available. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals no more than 5
times.
2. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The
system may be under heavy traffic conditions or have time
slots out-of-service due to TDM-BUS errors.
1. Refer to “TDM-BUS” to diagnose any active TDM-BUS
errors.
2. If the system has no TDM-BUS errors and is not handling
heavy traffic, retry the command at 1-minute intervals no
more than 5 times.
3. If the test continues to abort, escalate the problem.
Continued on next page
To Next Page
Loading...
