ANN-PT (Announcement Port)
Issue 4 May 2002
10-157 555-233-123
4. Either the announcement data module is busy or all the administered
NETCON data modules are busy.
5. There is no tape in the system.
6. The tape in the system does not have a valid announcement file saved
on it.
NOTE:
Unlike translations, there is no provision in the system for automatically
saving announcements to the system tape.
Hardware Error Log Entries and Test to Clear
Val ues
Notes:
a. This error type indicates that the circuit pack has been removed or has
been insane for more than 11 minutes. To clear the error, reinsert or
replace the circuit pack.
Table 10-51. Announcement Port Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
0
1
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0 Any Any Any test port PCSSpp sh r 1
1 Playback Speech
Memory Array (PSMA)
Test (#206)
MINOR ON test port PCSSpp sh r 3
18 0 The port was busied out WARNING OFF release port PCSSpp
130 (a) None WARNING ON test port PCSSpp sh
257 Channel Administration
Memory Array (CAMA)
Test (#205)
MINOR ON test port PCSSpp l r 3
17667 In-line error
513 140AY Channel Sanity
Inquiry Test (#222)
MINOR ON test port PCSSpp sh r 3
17684 In-line error
769 (b) None
To Next Page
Loading...
