Reset commands
Issue 4 May 2002
4-3555-233-123
Reset System 2 (System Cold Start
Without Translations Loading)
All Port circuit packs are reset. All telephone sessions are dropped. Telephones
begin to reconnect to the switch within 30 seconds. In a large system,
reconnection of all telephones may take up to five minutes.
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. In addition, the TDM Bus and all port circuit packs are reset.
Typical display
Reset System 3 (System Cold Start
With Translations Loading)
Emergency Transfer is invoked. Translations reload from translation card.
Depending on the translations, the reloading process could take from five to 30
seconds. Thereafter, all port circuit packs are reset, and all telephone sessions
drop. Telephones begin to reconnect to the switch within 30 seconds. In a large
system, reconnection of all telephones may take up to five minutes.
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. After the software is reset, all translations load from translation card. In
addition, the TDM Bus and all port circuit packs are reset.
INTERNAL REGISTER TEST PASSED
LOCAL BUS TEST PASSED
ROM CHECKSUM TEST PASSED
CONTROL STATUS TEST PASSED
DCACHE TEST PASSED
ICACHE TEST PASSED
WRITE BUFFER TEST PASSED
BTO TEST PASSED
TIMER TEST PASSED
RESET 2 (COLD_2) PERFORMED
To Next Page
Loading...
