Cisco MDS 9000 Series Command Reference

Send documentation comments to mdsfeedback-doc@cisco.com
22-131
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show interface
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
16 receive B2B credit remaining
3 transmit B2B credit remaining.
The following example shows how to display information about the in-band interface.
switch# show interface sup-fc0
sup-fc0 is up
Hardware is FastEthernet, address is 0000.0000.0000
MTU 2596 bytes, BW 1000000 Kbit
66 packets input, 7316 bytes
Received 0 multicast frames, 0 compressed
0 input errors, 0 frame, 0 overrun 0 fifo
64 packets output, 28068 bytes, 0 underruns
0 output errors, 0 collisions, 0 fifo
0 carrier errors
The following example shows how to display information about a VSAN interface.
switch# show interface vsan 2
vsan2 is up, line protocol is up
WWPN is 10:00:00:05:30:00:59:1f, FCID is 0xb90100
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit
0 packets input, 0 bytes, 0 errors, 0 multicast
0 packets output, 0 bytes, 0 errors, 0 dropped
The following example shows how to display description information for all interfaces.
switch# show interface description
fc1/1
no description
fc1/2
no description
fc1/15
fcAnl
sup-fc0 is up
mgmt0 is up
vsan1 - IPFC interface
port-channel 15
no description
port-channel 98
no description
The following example shows how to display brief information for a range of interfaces.
switch# show interface fc2/1 - 5 brief
-------------------------------------------------------------------------------
Interface Vsan Admin Admin Status Oper Oper Port-channel
Mode Trunk Mode Speed
Mode (Gbps)
-------------------------------------------------------------------------------
fc1/1 1 auto on down -- -- --
fc1/2 1 auto on fcotAbsent -- -- --
fc1/3 1 F -- notConnected -- -- --
fc1/4 1 auto on fcotAbsent -- -- --
fc1/5 1 F -- up F 2 --
fc1/6 1 auto on fcotAbsent -- -- --

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available