Cisco MDS 9000 Series

Send documentation comments to mdsfeedback-doc@cisco.com
22-134
Cisco MDS 9000 Family Command Reference
OL-8413-07, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show interface
2 Active TCP connections
Control connection: Local 43.1.1.2:3225, Remote 43.1.1.1:65532
Data connection: Local 43.1.1.2:3225, Remote 43.1.1.1:65534
30 Attempts for active connections, 0 close of connections
TCP Parameters
Path MTU 1500 bytes
Current retransmission timeout is 300 ms
Round trip time: Smoothed 10 ms, Variance: 5
Advertised window: Current: 122 KB, Maximum: 122 KB, Scale: 1
Peer receive window: Current: 114 KB, Maximum: 114 KB, Scale: 1
Congestion window: Current: 2 KB, Slow start threshold: 1048560 KB
5 minutes input rate 64 bits/sec, 8 bytes/sec, 0 frames/sec
5 minutes output rate 64 bits/sec, 8 bytes/sec, 0 frames/sec
866 frames input, 80604 bytes
866 Class F frames input, 80604 bytes
0 Class 2/3 frames input, 0 bytes
0 Error frames timestamp error 0
864 frames output, 80048 bytes
864 Class F frames output, 80048 bytes
0 Class 2/3 frames output, 0 bytes
0 Error frames 0 reass frames
16 receive B2B credit remaining
3 transmit B2B credit remaining.
The following example shows how to display information about a Gigabit Ethernet interface.
switch# show interface gigabitethernet 4/1
GigabitEthernet4/1 is up
Hardware is GigabitEthernet, address is 0005.3000.2e12
Internet address is 100.1.1.2/24
MTU 1500 bytes, BW 1000000 Kbit
Port mode is IPS
Speed is 1 Gbps
Beacon is turned off
5 minutes input rate 32 bits/sec, 4 bytes/sec, 0 frames/sec
5 minutes output rate 88 bits/sec, 11 bytes/sec, 0 frames/sec
637 packets input, 49950 bytes
0 multicast frames, 0 compressed
0 input errors, 0 frame, 0 overrun 0 fifo
659 packets output, 101474 bytes, 0 underruns
0 output errors, 0 collisions, 0 fifo
0 carrier errors
The following example shows how to display information about an iSCSI interface.
switch# show interface iscsi 2/1
iscsi2/1 is up
Hardware is GigabitEthernet
Port WWN is 20:41:00:05:30:00:50:de
Admin port mode is ISCSI
Port mode is ISCSI
Speed is 1 Gbps
iSCSI initiator is identified by name
Number of iSCSI session: 7, Number of TCP connection: 7
Configured TCP parameters
Local Port is 3260
PMTU discover is disabled
Keepalive-timeout is 1 sec
Minimum-retransmit-time is 300 ms
Max-retransmissions 8
Sack is disabled
Minimum available bandwidth is 0 kbps
Estimated round trip time is 0 usec
5 minutes input rate 265184 bits/sec, 33148 bytes/sec, 690 frames/sec