Engine
SHOP MANUAL
Ch 1 page 61
5.
Remove the rocker arm shaft.
6.
Remove the bearing bracket.
7.
Remove the pushrods.
Note: The pushrod for the unit injector is
secured with a retaining ring. Jiggle
and pull carefully on the pushrod to
loosen it.
8.
Remove the valve bridges.
9.
Remove the lower rocker cover.
If the spring comes loose from the unit injector, the unit
injector must be renewed.
Do not lean over the engine when removing the rocker arm
shaft. The unit injector spring is pre-tensioned and can
come loose, causing personal injury.
WARNING
NOTE
Figure 100
Figure 101
To Next Page
Loading...