SHOP MANUAL
Engine
Ch 1 page 62
10.
Remove the fork clamp bolt holding the unit
injector in place.
11.
Detach the cables on the unit injector. The
screws cannot be removed but undo them as
far as possible.
12.
Turn the unit injector anti-clockwise until it
stops. Place the slide hammer 87 596
between the solenoid valve and the edge of
the lower rocker cover as illustrated.
Place the slide hammer as indicated by
the arrow.
1. Fork clamp
2. Fork clamp bolt
3. Unit injector
Do not lift the unit injector by the spring. The spring can come
loose.
If the slide hammer is placed directly under the solenoid
valve, there is a risk of breaking the solenoid valve.
NOTE
NOTE
Figure 102
Figure 103
Figure 104
To Next Page
Loading...