SHOP MANUAL
Engine
Ch 1 page 126
8133
1. Press the shaft out of the bearing.
2. Press the bearing inner race shell from the
shaft and remove the retaining ring.
3. Place the removed bearing inner race in the
bearing and press out the bearing using drift
8413
4. Press a new bearing onto the shaft journal
using drift 8413.
5. Press the bearing and shaft journal into the
intermediate gear using drift 8133
6. Fit the snap ring.
7. Press the spacing ring onto the shaft journal.
Ensure that the shaft journal is on the press
table.
Do not press on the outer race.
NOTE
Figure 243
Figure 244
To Next Page
Loading...