SHOP MANUAL
Engine
Ch 1 page 132
8036
8
6. Take the threaded stem and insert the end
with flange nut number 1 from the rear
edge of the engine past the rearmost
bearing seat. Insert it further through the
bearing seats and the new bearings until
flange nut 1 protrudes from the front of the
engine.
7. Screw the flange part of tool 8467
securely onto hydraulic cylinder 8036
with two M6x12 bolts. Press together
cylinder 8036 if not already in neutral
position.
8. Screw the flange securely to the hydraulic
cylinder at the rear of the engine with two
of M10x25.
9. Screw on flange nut 8, from tool 8467,
onto the threaded stem.
Figure 259
Figure 260
To Next Page
Loading...