GENERAL INSTRUCTIONS
SHOP MANUAL
Ch 0 page 23
Operation in Extreme Heat
Continuous operation of machine in high temperatures can cause
machine to overheat. Monitor engine and hydraulic system tempera-
tures and stop machine to let it cool, when necessary.
1. Frequently inspect and maintain fan and radiator. Check coolant
level in radiator. Check grilles and radiator fins for accumulation
of dirt, debris and insects which could block cooling passages.
• Formation of scale and rust in cooling system occurs more rapidly
in extremely high temperatures. Change antifreeze each year to
keep corrosion inhibitor at full strength.
• If necessary, flush cooling system periodically to keep passages
clear. Avoid use of water with a high alkali content which increases
scale and rust formation.
Do not store acid type storage batteries near stacks of tires. Acid
fumes can damage rubber.
2. Check level of battery electrolyte daily. Keep electrolyte above
plates to prevent damage to batteries. Use a slightly weaker
electrolyte solution in hot climates. Batteries self-discharge at a
higher rate if left standing for long periods at high temperatures.
If machine is to stand for several days, remove batteries and
store in a cool place.
3. Service fuel system as directed in Operation and Maintenance
Manual. Check for water content before filling fuel tank. High
temperatures and cooling off cause condensation in storage
drums.
4. Lubricate as specified in Operation and Maintenance Manual
Lubrication Decal on machine.
5. Do not park machine in sun for long periods of time. If possible,
park machine under cover to protect it from sun, dirt and dust.
A. Cover machine if no suitable shelter is available. Protect
engine compartment and hydraulics from dirt and debris.
B. In hot, damp climates, corrosion will occur on all parts of
machine and will be accelerated during rainy season. Rust
and paint blisters will appear on metal surfaces and fungus
growth will appear on other surfaces.
C. Protect all unfinished, exposed surfaces with a film of pre
servative lubricating oil. Protect cables and terminals with
ignition insulation compound. Apply
paint or suitable rust preventive to damaged surfaces to pro
tect them from rust and corrosion.
NOTE
To Next Page
Loading...