SHOP MANUAL
GENERAL INSTRUCTIONS
Ch 0 page 24
Operation In Dusty and Sandy Areas
Operation of machine can cause dust in almost any area.
However, when in predominantly dusty or sandy areas,
additional precautions must be taken.
1. Keep cooling system fins and cooling areas clean. Blow out with compressed
air, if possible, as often as necessary.
Wear goggles when using compressed air to prevent face or eye injury.
2. Use care when servicing fuel system to prevent dust and sand from entering
tank.
3. Service air cleaner at frequent intervals, check air restriction indicator daily
and keep dust cup and dust valve clean. Prevent dust and sand from entering
engine parts and compartments as much as possible.
4. Lubricate and perform services outlined on current lubrication chart on ma-
chine and Operation and Maintenance Manual. Clean all lubrication fittings
before applying lubricant. Sand mixed with lubricant becomes very abrasive
and accelerates wear on parts.
5. Protect machine from dust and sand as much as possible. Park machine under
cover to keep dust and sand from damaging unit.
Operation in Rainy or Humid Conditions
Operation under rainy or humid conditions is similar to that as in extreme heat
procedures previously listed in addition:
1. Keep all exposed surfaces coated with preservative lubricating oil. Pay particu-
lar attention to damaged or unpainted surfaces. Cover all paint cracks and chip
marks as soon as possible to prevent corrosive effects.
Operation in Saltwater Areas
Saltwater and saltwater spray is very corrosive. When operating in saltwater areas,
or in or around snow, observe the following precautions:
1. When exposed to saltwater, dry machine thoroughly and rinse with freshwater,
as soon as possible.
2. Keep all exposed surfaces coated with preservative lubricating oil. Pay atten-
tion to damaged paint surfaces.
3. Keep all painted surfaces in good repair.
4. Lubricate machine as prescribed on lubrication chart on machine or Operation
and Maintenance Manual. Shorten lubricating intervals for parts exposed to
salt water.
5. Check operating controls to ensure proper functionality and that they return to
"NEUTRAL" when released.
WARNING
To Next Page
Loading...