SHOP MANUAL
GENERAL INSTRUCTIONS
Ch 0 page 38
Assembly
• Thoroughly clean all parts before assembly. Wash clean those parts relating to the drive line. Also, check
for scratches and nicks on the surfaces of the parts and repair, if any. Wash new parts to remove rust
preventives, if coated, before assembly. Use trichloroethylene or diesel fuel.
• Employ a press or a driving tool when assembling bearings, bushings and oil seals. When installing a
bearing, pay attention to keep the marking on the bearing facing outward, unless it is necessary to install
otherwise because of the construction (this permits easy identifying of the bearing installed).
• Be sure to positively lock bolts and nuts which are usually invisible from the outside or used for some
important parts that require locking, by the use of wires, cotter pins or lockwasher.
To Next Page
Loading...