SHOP MANUAL
GENERAL INSTRUCTIONS
Ch 0 page 42
• To press-fit a small bearing having a little
interference, use of a jig shown below is
recommended. In this case, be careful to press only
the inner race. Should the outer race be forced,
dents will be produced on the sliding surfaces
between the races.
• To install a non-separate type bearing in which
both the inner and outer races require interference,
press-fit both races at a time by means of a screw
press or a hydraulic press. Do not drive the bearing
in with a hammer, this is liable to damage the bear
ing races.
To Next Page
Loading...