Introduction CDHD
10 VarCom Reference Manual
Drive status Enabled | Disabled
Indicates the required state of the drive when the command
or variable is issued or invoked.
Range Discrete values and ranges of values.
Parameter values can be written with up to 9 digits
following the decimal point. When read, values will show
only 3 digits following the decimal point.
For example:
-->acc 0.123456789
-->acc
0.123 [rpm/s]
Default value The parameter’s default value.
Unit When parameter values imply units of measure, these units
are specified.
Non-volatile Yes | No
Indicates whether the value of the variable is stored in the
non-volatile memory, and thereby available when the drive
is rebooted.
Not applicable for Command.
Example
Examples of use.
See also Links to related commands and variables.
CANopen Where applicable, the equivalent EtherCAT COE and
CANopen object code.
To Next Page
Loading...
