Variables and Commands CDHD
50 VarCom Reference Manual
CANBITRATE
Definition CAN Bit Rate
Type Variable (R/W)
Description Gets/sets the CAN bit rate.
When the drive is powered, it assumes the bit rate of any
existing conversation on the communication bus. If no such
communication is detected, the drive sets the communication
rate to the CANBITRATE value.
For the CANBITRATE setting to take effect, a SAVE command
followed by a cycle power sequence must be executed.
Syntax CANBITRATE
CANBITRATE <value>
Firmware 1.3.2
Drive status Enabled | Disabled
Range 1 = 125 kbps
2 = 250 kbps
3 = 500 kbps
4 = 1000 kbps
Default value 3
Unit Not Applicable
Non-volatile Yes
See also
To Next Page
Loading...
