CDHD Variables and Commands
VarCom Reference Manual 369
STOPPED
Definition Position Motion Ended
Type Variable (R)
Description Reports whether the position profile generated by MOVEINC
and MOVEABS has been completed, therefore allowing the
next command to be issued.
Syntax STOPPED
Firmware 1.0.6
Drive status Enabled | Disabled
Range -1 = Movement was interrupted (e.g., due to Disable)
0 = Not completed
1 = Profile completed
2 = Profile completed and drive is in position (INPOS)
Default value Not Applicable
Unit Not Applicable
Non-volatile No
See also HOLD
PEINPOS
PEMAX
PTPVCMD
V
VCMD
To Next Page
Loading...
