Variables and Commands CDHD
70 VarCom Reference Manual
DISTIME
Definition Active Disable Time
Type Variable (R/W)
Description Gets/sets the amount of time to wait after motor speed goes
below DISSPEED before the drive is disabled by the Active
Disable function. This delay is typically set to accommodate
brake engage time.
Note: To use the Active Disable function effectively, a
position controller must be configured.
Syntax Read: DISTIME
Write: DISTIME <value>
Firmware 1.0.6
Drive status Enabled | Disabled
Range 0 to 6500
Default value 10
Unit ms
Non-volatile Yes
See also DECSTOP
DISMODE
DISSPEED
FLT
CANopen 204Bh, sub-index 0
To Next Page
Loading...
