CDHD Variables and Commands
VarCom Reference Manual 371
SWENMODE
Definition Software Enable on Power-Up
Type Variable (R/W)
Description Gets/sets the state of the software enable switch when the
drive is powered up.
Syntax Read: SWENMODE
Write: SWENMODE <value>
Firmware 1.0.6
Drive status Enabled | Disabled
Range 0 = Software enable is off at power-up
1 = Software enable is on at power-up
Default value 0
Unit Not applicable
Non-volatile Yes
See also ACTIVE
EN
READY
SWEN
To Next Page
Loading...
