Variables and Commands CDHD
52 VarCom Reference Manual
CLEARFAULTS
Definition Clear Faults
Type Command
Description Clears latched faults.
Once all faults are cleared, the drive becomes ready for
activation (READY).
If clearing the faults causes the drive to re-enable, then
software enable (SWEN) is disabled to prevent spontaneous
re-enable.
Syntax CLEARFAULTS
Firmware 1.0.6
Drive status Enabled | Disabled
Range Not Applicable
Default value Not Applicable
Unit Not Applicable
Non-volatile Not Applicable
See also DISMODE
FLT
FLTHIST
FLTHISTCLR
To Next Page
Loading...
