CDHD Variables and Commands
VarCom Reference Manual 391
UVMODE
Definition Under-Voltage Mode
Type Variable (R/W)
Description Gets/sets a value that defines how the drive will respond to
an under-voltage fault.
Syntax Read: UVMODE
Write: UVMODE <value>
Firmware 1.0.6
Drive status Enabled | Disabled
Range 0 = Latches fault immediately.
1 = Shows warning only (when disabled, does not display
warning).
2 = Shows warning, then waits UVTIME before the fault is
latched (when disabled, does not display warning).
3 = Fault only if under-voltage exists and drive is enabled.
Default value 0
Unit Not Applicable
Non-volatile Yes
See also UVRECOVER
UVTHRESH
UVTIME
VBUS
VBUSREADOUT
CANopen 20CDh, sub-index 0
To Next Page
Loading...
