CDHD Variables and Commands
VarCom Reference Manual 51
CHECKSUM
Definition CHECKSUM
Type Variable (R/W)
Description Enables/disables checksum protection on messages
communicated between drive and host.
The checksum is an 8-bit value, displayed within brackets
<>. For example, 0x1F checksum is displayed as <1F> at
the end of the message before the carriage return.
Syntax Read: CHECKSUM
Write: CHECKSUM <value>
Firmware 1.0.6
Drive status Enabled | Disabled
Range 0 = Message checksum disabled
1 = Message checksum enabled
Default value 0
Unit Not Applicable
Non-volatile Yes
See also COMMODE
ECHO
MSGPROMPT
To Next Page
Loading...
