Variables and Commands CDHD
370 VarCom Reference Manual
SWEN
Definition Software Enable Status
Type Variable (R)
Description Indicates the state of software enable. This condition can be
toggled using the EN an K commands.
Syntax SWEN
Firmware 1.0.6
Drive status Enabled | Disabled
Range 0 = Software enable switch disabled (K command has been
issued)
1 = Software enable switch enabled (EN command has been
issued)
Default value Not Applicable
Unit Not Applicable
Non-volatile No
See also ACTIVE
EN
FLT
K
READY
REMOTE
ST
SWENMODE
To Next Page
Loading...
