Servotronix CDHD - Page 175

CDHD Variables and Commands
VarCom Reference Manual 175
K
Definition Disable Command
Type Command
Description Disables the drive. The behavior of the drive upon disable
command is defined by DISMODE.
K removes the software enable condition (SWEN) from the
activation chain.
Syntax K
Firmware 1.0.6
Drive status Enabled | Disabled
Range Not Applicable
Default value Not Applicable
Unit Not Applicable
Non-volatile Not Applicable
See also ACTIVE
EN
FLT
READY
REMOTE
ST
SWEN