4. Remove the transport lock screws and remove the transport lock.
Converter in degree of protection IP20 Converter in degree of protection IP55
① Transport lock screws
② Transport lock
① Transport lock screws
② Transport lock
5. Use lifting equipment attached to the converter attachment points.
Converter in degree of protection IP20 Converter in degree of protection IP55
① Attachment points for lifting equipment
② Plate with additional attachment points
After installing the converter in an electrical cab‐
inet, remove the plate with the additional holding
points from the lower side of the converter.
① Sheet steel plates for lifting equipment
After installing the converter in an electrical cab‐
inet, remove the sheet steel plates for the lifting
equipment.
Installation
5.4Unpacking the converter, delivered on pallets
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 99
To Next Page
Loading...
