Siemens SINAMICS G220 - Overview of the Guided Quick Startup

11.4 Overview of the guided quick startup
Overview
The guided quick startup is a drive commissioning wizard. You can use the wizard to make the
basic settings for the drive. It preassigns drive settings for the intended application.
Requirement
You need the following Engineering rights to run the guided quick startup if project protection
is activated:
• Edit hardware con󹪝guration
• Edit drive applications
Description of function





① Make detailed settings for the active quick startup area
② Active quick startup area (highlighted)
③ Icons: store data in a power-independent manner, restore factory setting (each in online mode)
④ Select active data sets (CDS, DDS)
⑤ Icons: Start editing/Finish editing
⑥ Icons: one step forward or back
Figure11-1 Example: Guided quick startup in o󹪠ine mode
Commissioning (Startdrive)
11.4Overview of the guided quick startup
SINAMICS G220 converter
288 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB