Siemens SINAMICS G220 - Profienergy; Energy-Saving Mode; Energy-Saving Mode 2

Designation Format Example for the content
SOFTWARE_REVISION char, u8[3] "V" 06.02.00
REVISION_COUNTER u16 0000hex
PROFILE_ID u16 3A00hex
PROFILE_SPECIFIC_TYPE u16 0000hex
IM_VERSION u8[2] 01.02
IM_SUPPORTED bit[16] 001Ehex
14.4.10 PROFIenergy
14.4.10.1 Energy-saving mode
Overview
PROFIenergy is a pro󹪝le for energy management in production systems. PROFIenergy uses the
PROFINET communication protocol.
Description of function
The higher-level control transfers the control commands and status queries in acyclic operation
via data record 80A0hex.
The converter supports PROFIenergy pro󹪝le V1.3 and function unit class 3.
The converter supports energy-saving mode 2.
14.4.10.2 Energy-saving mode 2
Overview
The converter supports hibernation mode 2.
Description of function
The converter exhibits the following behavior when hibernation mode 2 is active:
• Communications via PROFINET continues to run without any interruption.
• None for energy-saving relevant shutdown in the converter power unit.
• The converter does not send any diagnostic interrupts.
• p5611 de󹪝nes whether the motor stops when transitioning into hibernation mode 2.
• When transitioning into hibernation mode 2, the converter can control or switch-o󹪜 other
devices. To do this, numerical signal source r5613 must be interconnected, e.g. with a digital
output.
Functions
14.4PROFINET communication
SINAMICS G220 converter
378 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB