Siemens SINAMICS G220 - Dynamic Drive Control Operating Mode; Differences between Speed Control and Dynamic Drive Control; Setting of Technological Application in Dynamic Drive Control

14.10.3 Dynamic Drive Control operating mode
14.10.3.1 Di󹪜erences between speed control and Dynamic Drive Control
Overview
Selecting the Dynamic Drive Control operating mode in quick setup simpli󹪝es the structure of
the speed control, which reduces the setting options.
Requirement
Dynamic Drive Control works with the following motors:
• Induction motor
• Synchronous motor without starting cage
• Reluctance motor without starting cage
Description of function
Setting options with and without selection of the Dynamic Drive Control operating modes:
 Speed control after selection of the
Dynamic Drive Control operating
mode
Speed control without select‐
ing an operating mode
Closed-loop torque control
without higher-level speed
controller
Not possible Possible
Droop Not possible Possible
K
P
- and T
I
adaptation Simpli󹪝ed Advanced
Hold or set the integral com‐
ponent of the speed control‐
ler
Not possible Possible
Acceleration model for pre‐
control
Default setting Can be activated
Motor data identi󹪝cation at
standstill or with rotating
measurement
Shortened, with optional transition into
operation
Complete
14.10.3.2 Setting of technological application in Dynamic Drive Control
Overview
The selected technological application optimizes the calculation of the open-loop and closed-
loop control parameters in Dynamic Drive Control operating mode.
Functions
14.10Closed-loop drive control
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 473