Siemens SINAMICS G220 - Series Commissioning with Memory Card

12.2 Series commissioning with memory card
Overview
For "Series commissioning using a memory card" transfer the settings of converter 1 using a
memory card to converter 2 or to additional converters.
Procedure
Proceed as follows to perform series commissioning using a memory card:
1. Switch o󹪜 the supply voltage of converter 1.
2. Insert an empty SD card with a maximum capacity of 32 GB (e.g.: 6SL5970‑0AA00‑0AA0)
into the card slot of converter 1.
3. Switch on the supply voltage of converter 1.
4. Commission the converter.
5. Save the settings retentively at the end of commissioning.
This means that you save the settings retentively not only in converter 1 but also to the
memory card.
6. Switch o󹪜 the supply voltage of converter 1.
7. Remove the memory card from converter 1.
8. Switch o󹪜 the supply voltage of converter 2.
9. Insert the memory card into converter 2.
10.Switch on the supply voltage of converter 2 and wait until the RDY LED lights green.
Converter 2 takes the settings of converter 1 from the memory card, including the following
settings:
– User management
– Access control
– IP con󹪝guration
– Device name
11.Switch o󹪜 the supply voltage of converter 2.
12.Remove the memory card from converter 2.
Repeat steps 8to12 for all additional converters to which you wish to transfer these settings.
Series commissioning
12.2Series commissioning with memory card
SINAMICS G220 converter
298 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB