16.2 Restore factory settings
Description
The reset to factory settings with a commissioning tool (web server, Startdrive) only deletes the
user-specic parameterization of the converter, for example motor data.
The following settings are retained with the reset:
• Activation and settings of User Management & Access Control
• The communication settings "IP conguration" and/or "Device name" of the following
interfaces:
– Service interface X127
– PROFINET interface X150
– Interface X128 to the edge device if option module OM-IIoT is inserted
• Installed rmware on the converter
Corrective maintenance
16.2Restore factory settings
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 767
To Next Page
Loading...
