Siemens SINAMICS G220 - Important Product Information; Intended Use

1.5 Important product information
1.5.1 Intended use
Requirement
WARNING
Death or serious injury if not used as intended
Not using as intended can result in hazardous states.
• Carefully observe the description of intended use
Note
It cannot be guaranteed that EMC emission limits are complied with if the products are
connected to an isolated line supply grounded through a high ohmic connection or a line supply
with grounded line conductor.
• Draw-up an EMC plan to comply with the EMC requirements of the intended application.
Description
The products described in this document, together with software, accessories and options, form
an electric drive to supply low-voltage, three-phase motors.
The products are professional devices for stationary indoor use in industrial, light-industrial
and commercial applications and are intended for supply from a non-public (industrial)
low-voltage network. The products are not intended for use in residential areas and are not
intended for supply from a public low-voltage network.
The products must be correctly transported and stored and must be installed, commissioned
and maintained by professionals who have adequate knowledge to implement the safety,
cybersecurity and EMC measures in accordance with the speci󹪝cations described in this
manual and recognized state-of-the-art engineering practice.
You may only use the products when the following requirements are complied with:
• All regulations and directives that are applicable at the place of 󹪝nal use, especially with
regard to electrical safety, functional safety and electromagnetic compatibility (EMC).
• All instructions, notes, technical speci󹪝cations, safety information, and cybersecurity
information contained in this document and other supporting documentation.
The products are part of a machine or system. They must guarantee the safety of persons
and material assets as well as electromagnetic compatibility by applying suitable measures
when designing the system.
A risk assessment of the complete application, including third-party products and
implementation of adequate safety and cybersecurity measures must be performed before
you use the product.
Introduction
1.5Important product information
SINAMICS G220 converter
24 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB