Siemens SINAMICS G220 - Dimension Drawing OM-Iiot; Mounting Option Module OM-DQ, Converter in Degree of Protection IP20

5.7.9 Dimension drawing OM-IIoT
Dimension drawing
NN

NN
Figure5-23 Dimensions of Option Module OM-IIoT
5.7.10 Mounting option module OM-DQ, converter in degree of protection IP20
Overview
Option module OM-DQ is mounted in the option slot of the converter.
Requirement
NOTICE
Damage to the option module by withdrawing and inserting under voltage (hot
swapping)
Withdrawing and inserting the option module when the power supply is switched on can
damage the option module or cause the option module to malfunction.
• Switch o󹪜 the converter power supply before you withdraw or insert the option module.
Option module OM-DQ must be mounted as the lowermost module in the option slot of the
converter because this module does not have a connector for other option modules.
You will need a torx T20 screwdriver.
Installation
5.7Option modules
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 121