Siemens SINAMICS G220 - Page 124

Procedure




Figure5-24 Mounting option module OM-DQ in the option slot of the IP20 converter
Proceed as follows to mount option module OM-DQ in the option slot of the converter:
1. Remove the front cover (frame size FSA) or open the front door of the converter.
2. Open the front door of the converter.
3. Push option module OM-DQ up until it snaps in 󹪞ush.
4. Tighten the 󹪝xing screw with a T20 torx screwdriver, applying a torque of 2 Nm.
5. Press the cover caps onto the 󹪝xing screws.
6. Place the front cover (frame size FSA) on the converter or close the front door of the
converter.
Result
Option module OM-DQ is connected to the converter.
Installation
5.7Option modules
SINAMICS G220 converter
122 Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB