Siemens SINAMICS G220 - I;O Presetting Fieldbus with Data Set Switchover

c0840[0...n] ON / OFF (OFF1) 
p1001[0...n] Fixed speed setpoint 1 [rpm]
p1002[0...n] Fixed speed setpoint 2 [rpm]
p1003[0...n] Fixed speed setpoint 3 [rpm]
p1004[0...n] Fixed speed setpoint 4 [rpm]
p1016 Fixed speed setpoint select mode 
c1020[0...n] Fixed speed setpoint selection bit 0 
c1021[0...n] Fixed speed setpoint selection bit 1 
c1022[0...n] Fixed speed setpoint selection bit 2 
c1023[0...n] Fixed speed setpoint selection bit 3 
r1024 Fixed speed setpoint e󹪜ective [rpm]
c1070[0...n] Main setpoint 
c2103[0...n] 1st acknowledge faults 
14.8.1.2 I/O presetting "Fieldbus with data set switchover"
Overview
In order to avoid having to successively change terminal by terminal, multiple terminals can be
set jointly with one operating unit.
With the I/O preset "Fieldbus with data set switchover", the converter is prepared for
operation on the 󹪝eldbus.
Requirement
The preset can only be changed using the Startdrive commissioning tool or the web server.
The preset is only useful if a 󹪝eldbus telegram has been con󹪝gured.
Description
The I/O preset "Fieldbus with data set switchover" is the factory setting of the converter with
PROFINET interface.
The converter obtains its signals via the 󹪝eldbus. With 1 signal at digital input DI3, the motor
can be traversed via the digital inputs DI0 and DI1.
Functions
14.8Inputs/outputs
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 419