Siemens SINAMICS G220 - Support Menu; Scanning the IP Address

You change the language setting in menu "System" > menu item "Settings" > "Language".
Procedure
To change the language setting, proceed as follows:
1. In the navigation bar, navigate to the "System" menu.
Con󹪝rm the selection using the "OK" key.
The "System" menu opens.
2. Select the "Settings" menu item.
Con󹪝rm the selection using the "OK" key.
3. Select the "Language" menu item.
Con󹪝rm the selection using the "OK" key.
4. Select the language required.
Con󹪝rm the selection using the "OK" key.
13.5.5 "Support" menu
13.5.5.1 Scanning the IP address
Overview
The IP address of the converter is displayed in menu "Support" > "Scan IP address", and also
available via a QR code.
You can connect to the converter web server using the IP address.
You have the following options depending on the operating unit:
• Scanning the QR code of the IP address using a mobile device
• Manually entering the IP address, e.g. at a computer, laptop
Requirement
• You have connected the mobile device to the drive via the WLAN or via a USB OTG (on-the-go)
adapter.
• You have connected the computer/laptop to service interface X127 or PROFINET interface
X150 via cable.
Operation and monitoring with SINAMICS SDI Standard
13.5Functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 317